LED strip Bergmen COB RGB WW-DW / COB840 / 24VDC / 21W / 422-425lm / 180° / RGB+2700K-6500K / RGB + warm white + daylight white / IP20 / roll 5m
The Bergmen COB LED strip allows you to obtain a uniform line of light, even when mounted in a very shallow profile. It is characterized by very good luminous efficiency, defining the ratio of the luminous flux emitted by the light source to the power consumed by it [lm/W]. Possibility to adjust the light color: RGB, selection of white color in the range of 2700-6500 K.
Tape width 12 mm, cutting section 3.6 cm, standard roll length 5 m.
Technical parameters apply to one meter of LED strip. Price applies to a roll of 5 m.
Due to maintaining the uniformity of lighting in the case of a maximum distance of 5 m, it is recommended to connect it to the power source on both sides.
For proper operation of the tape, it is necessary to use a power supply with an output voltage of 24 V DC and a power adjusted to the length of the tape. For 5 meters of COB RGB tape, use a power supply with min. power 130 W.
To create a complete RGB LED installation, in addition to the strip and power supply, you must select an appropriate controller. Depending on your needs, it is possible to use a Bluetooth, radio, infrared or Wi-Fi controller. The controller is mounted between the RGB strip and the power supply and is responsible for controlling the light along the entire length of the strip. The controller allows you to both change the light color and control the light intensity.
The Bergmen COB LED strip is constructed using modern COB (Chip on Board) diodes, mounted in large numbers on a small surface. All diodes are placed under a common phosphor layer. This solution allows you to achieve the effect of a uniform line of light without visible light points. The design of the COB tape allows it to be cut to the length required for a given project. The Bergmen COB LED strip can be used in a variety of projects, both as functional and decorative lighting.